Online Message

Message

    Product List

    Hot News

Graphite grinding mill

Products overview

Finished graphite powder fineness: 47-5 micron (325mesh-2500mesh) Capacity: 0.4-12T per hour Models of Graphite grinding mill : HGM80/HGM90/HGM100/HGM100A/HGM125 Input graphite ore size: 20mm Features

  •  

    Finished graphite powder fineness: 47-5 micron (325mesh-2500mesh)
    Capacity: 0.4-12T per hour
    Models of Graphite grinding mill: HGM80/HGM90/HGM100/HGM100A/HGM125
    Input graphite ore size: ≤20mm
    Features of Graphite grinding mill:
    1. High efficiency
    At the status of the same finish fineness and power, its production capacity per hour is twice as much as other jet mill, mixing grinder and ball mill.
    2. Long lifecycle of wearing parts
    The ring and rollers are forged by special material with high utilization. Under same grinding material and finish fineness, the wearing parts life cycle usually is one year, which is 2-3 times longer than impact mill and turbo mill. The service time can reach 2-5 years if grinding carbonate (calcium carbonate).
    3. High safety and reliability
    There are no rolling bearings and bolts in grinding cavity, so there are no problems caused by bolts shedding or wear of bearings and seal components.
    4. High fineness and flexible adjustment
    The final product fineness can be adjusted between 325 meshes and 2500 meshes (47 microns to 5 microns), and the product fineness can reach D97≤5μm.
    5. Environment friendly
    The application of pulse deduster and muffler alleviate the dust pollution and noise.
    Production Line Configuration of Graphite grinding mill:
     hammer crusher, bucket elevator, storage hopper, vibrating feeder, main unit, inverter classifier, cyclone collector, pulse deduster system, high pressure positive blower, air compressors and electrical control systems.
    Working Principle of Graphite grinding mill:
    The main bearing and each dial are driven by electromotor of main machine through reducer, and numbers of rollers, which are rolling in the ring, are driven by dial through plunger. After crushed by hammer crusher, the big materials become small ones and are sent to storage hopper by elevator and further sent to the middle of first dial evenly by the electromagnetic vibrating feeder and feeding pipe. The materials will be driven to the edge of dial by centrifugal force and fall down into the ring, crushed and grinded by roller, and become powder after production of three rings. The high pressure centrifugal blower will inhale air from outside and blow the crushed materials to classifier. The rotating turbo in the powder concentrator will make the coarse materials return to the mill and reground, while the fineness will mix with the air and go into the cyclone and be discharged in the discharge bin, which is at the bottom of it. The air, which mixed with very little fineness, will be purified by impulse duster and discharged by blower and muffler.